Walk along fluid of job of silk thread cut quickly make up

Fluid of line cut job is made up by special emulsification oil and tap water and become, it is better to use distilled water conditionally or magnetize water and emulsification oil to compound the effect, the chroma that working fluid makes up depends on the ply that processes work, material reachs treatment precision requirement character. From the point of workpiece ply, what ply is less than 30mm is thin model workpiece, working fluid chroma is between 15 ％ of 1O ％ ～ ; Of 30 ～ LOOmm in thick model workpiece, chroma is about between ％ of 1O of 5 ％ ～ ; Those who be more than 1OOmm is thick model workpiece, chroma is about between 5 ％ of 3 ％ ～ . Look from workpiece material character, easily the material that corrode removes, if the melting point such as copper, aluminium turns the material with low latent heat compatibly, can increase working fluid concentration appropriately, put electric energy in order to make full use of, improve treatment efficiency, but the electrode silk that also should choose bigger diameter at the same time has cut, with benefit at discharging bits sufficient. From the point of treatment precision, working fluid concentration is high, discharge space is little, workpiece surface surface roughness is better, but go against a bits, easy cause short circuit. When working fluid density is low, workpiece surface surface roughness is poorer, but benefit at discharging bits. Anyhow, compounding the situation that the basis answers to be machined actually when fluid of line cut job, consider above factor integratedly, in assure to discharge bits below the premise with successful, stable treatment, improve treatment surface quality as far as possible. CNC Milling