Numerical control lathe repairs whorl! You do not have the method that has seen certainly

Repair whorl, I think general car experienced worker is met, but it is not easy that numerical control car repairs whorl! I part below for! One, general car repairs whorl of course two kinds of circumstances need a workpiece to take dial gauge to search, whorl knife is placed can leaning on tool carrier, if the circle outside workpiece has plane, can take an example to place whorl knife general car repairs whorl easy, because can stop whorl knife in whorl,be among when, use small splint and in splint goes to the sew of point of a knife of whorl knife in whorl tooth, and can let two blade of whorl knife according to the feel of small splint of joint very good! 2, numerical control car repairs whorl numerical control car is bad to repair because do not have the feel of general car,be, cannot of joint so accurate I repaired a whorl with numerical control car today, m28*0.

Of 75 60° , 10 what rotate speed gives, this moment because rotate speed is slow, the very can clear positional condition point of a knife that sees whorl knife can control key for many times to tooth bottom, how to control key? Can change directly with wear and tear, toward left negative worth, toward value of right solicit comments, as to how much to change, can compare according to whorl size, as above graph can be gone to first right tone 0.

12mm, probably OK, if differ a few can move the 2nd times again (attention: I use the whorl of G76 car, whole process must use sheet paragraph) Z to after adjusting, it is OK to can change wear and tear to move X axis slowly! Conditional also can add the machine that make bid to use iron with line cut piece do this, efficiency will be taller! Of course, this is a few little thought of myself only, welcome everybody to criticize point out mistakes so that they can be corrected! CNC Milling